Size guide

Our denim is rigid with no stretch, so getting the waist right matters more than it does with regular jeans. Two minutes with a tape measure saves you a return.

Denim — how to measure

The easy way: grab a pair of jeans you already own that fit the way you want, lay them flat and buttoned, and measure straight across the waistband from edge to edge. Double that number. That’s your waist size — order it.

With a tape measure: wrap it around where you actually wear your jeans — usually just below the hip bone, not at your belly button. Keep it snug but not tight. Round up to the nearest even number.

Waist sizes we make

SizeWaist (inches)Roughly equals
2828″XS
3030″S
3232″M
3434″L
3636″XL
3838″XXL
4040″3XL
4242″4XL

Which cut should I get?

  • Vault 90 — the standard baggy. Roomy seat and thigh, straight leg that stacks over your shoes. Start here if you’re not sure.
  • Blueprint Wide-Leg — the widest we make, high rise. Get this if you want the leg to really move.
  • Offgrid Loose Taper — baggy up top, pulls in below the knee. Best first step if you’ve only worn skinny.
  • Carrier Carpenter — same as Vault 90 with workwear detailing. Same fit, more hardware.
  • Nightshift — Vault 90 fit, blacked-out everything.

Important: raw denim has zero stretch. If you’re between sizes, size up — it will mould to you but it will not grow. The waist relaxes about half an inch after the first few wears.


Tees

Cut boxy with a dropped shoulder, and pre-shrunk — so take your normal size. If you like a really oversized look, size up one.

SizeChest (to fit)
S34–36″
M38–40″
L42–44″
XL46–48″
XXL50–52″

Full garment measurements — inseam, leg opening, rise and body length for every size — go up here as soon as the first production run lands and we can measure the real thing. We’d rather publish nothing than publish numbers we haven’t checked ourselves.